26
General Safety Information Concerning
the Radinn jetboard – continued
• Before connecting the Radinn Power Pack
to the Radinn Charger, make sure that the
charging connector and battery connector are
clean and dry. Wet and/or dirty connections with
the battery and charger may cause a short cir-
cuit to occur - which can result in damaged bat-
tery electronics, re and explosions, resulting in
severe injury or death.
• Before operating the jetboard, make sure that
the battery is securely connected to the board.
• NEVER remove the deck pad and/or try to enter
the Jet compartment. Opening the Jet com-
partment and altering the internal components
can damage the sensors, motors, electronics
and/or software - which can result in the safety
functions and systems to fail and can potentially
cause permanent damage causing severe injury
or death.
• Never stick objects into holes, openings, con-
nectors or other electronics, hardware or soft-
ware. This may damage the components, parts
or board.
• Never try to service or repair anything other than
what is clearly specied. Service may only be
carried out by an authorized technician in order
to ensure safety of yourself, your environment
and the jetboard. Due to its modular design it
is unlikely that the entire jetboard will have to
be shipped to one of our facilities for service or
repair. It is much more likely that an authorized
Radinn retailer, dealer or distributor can replace
any damaged/broken component so that you
can be out in the water again in no time. Please
do not try to repair, service or maintain anything
yourself – for your own and your environment’s
safety.
SAFETY INFORMATION
To Next Page
Loading...