53
3 4
When the remote successfully pairs with
the board, all ve LEDs will ash once.
When the pairing is complete, the LEDs stop
ashing and indicates the remaining bat-
tery of the Power Pack. Charge the Power
Pack again if not all ve LEDs light up.
Then gently push the lever to check if it’s
properly paired. If there is no response
from the jet, please repeat from step 2.
BOARD PREPARATIONS
Note:
It will take between 15 to 60 seconds
to complete the pairing. If the remote
control does not nd the board after 60
seconds, repeat step 2.
To Next Page
Loading...