68
69
3 421
Fill the Radinn Rinse Bottle with fresh
water.
Connect the bottle to the jet outlet coo-
ling connector (A).
Squeeze the bottle until the water has
passed through the system.
Always repeat the procedure (1) after
every surf in salt water. Corrosion and salt
may clog the system and thereby decrea-
se the water ow and getting the motor
to overheat.
Once in a safe, dry location, remove the
battery. In the battery compartment, put
the connector protection in place, and
make sure it is tightly sealed around the
battery connector.
Rinse the entire board with fresh water
to ensure that all salt water is removed
to prevent corrosion.
Make sure that all parts are dry prior to pla-
cing them in the board bag or any other
storage equipment.
Radinn jetboard
Maintenance
MAINTENANCE MAINTENANCE
Note:
Do never store the battery in the board.
A
To Next Page
Loading...