Need help?Do you have a question about the Radio Engineering Industries HD5-1200 and is the answer not in the manual?
General| Brand | Radio Engineering Industries |
|---|---|
| Model | HD5-1200 |
| Category | DVR |
| Language | English |
Details video input, standards, resolution, frame rate, bit rate, compression, and storage options.
Guides on viewing live video and performing the initial setup of the DVR system.
Instructions for inserting and removing the Hard Disk Drive (HDD) module from the DVR.
Instructions for inserting and removing the SD card from the DVR's access slot.
Details the system wiring, including power cable connections and camera cable configurations.
Details the specific wire connections for vehicle sensor options, shown for school buses.
Instructions on how to start the recording process by starting the vehicle and turning on the system.
Procedures for stopping the recording process, including off-delay and download delays.
Lists the default IP address, Net Mask, Username, and Password for DVR network access.
Details the System section of the Setup menu, covering ID, Time & Date, Start Up, Faults, and Password.
Guides on configuring date, time, display format, and time synchronization options.
Covers settings for determining when the DVR starts/stops recording and its behavior after ignition off.
Details how to secure the DVR using local and remote passwords for setup access.
Covers video configuration including camera setup, recording times, sub-stream, and image settings.
Allows users to configure individual camera record settings like resolution, frame rate, and channel enable.
Guides on configuring IP and port settings for IP cameras connected to the DVR.
Allows DVR configuration for network connectivity including WAN/LAN, Server, Wi-Fi, and Cellular.
Configures motion detection settings for each camera, including sensitivity and area.
Provides options to configure the accelerometer, including calibration and alarm thresholds.
Allows DVR configuration for network connectivity including WAN/LAN, Server, Wi-Fi, and Cellular.
Describes how to upgrade the DVR firmware using a file from a PC.
Allows users to view any or all cameras in real-time, with controls for channel selection and info display.
Provides access to recorded videos for searching by time/date, alarm, or USB backup.
Enables searching for recorded videos by selecting a specific date and time from a calendar.
To Next Page
