4
2 Use your antenna
1. Fully extend the telescoping antenna elements.
2. For VHF TV Channels 2-13 and FM HD radio stations,
adjust the rotary knob until you get the best picture
and sound.
For UHF TV channels 14-69, rotate the base of the
antenna until you get the best picture and sound.
nNotes:
• Higher broadcast frequencies are noticeably affected by
obstructions.
• In weak-signal areas, you might get better reception by
doing the following:
For Channels 7-13 and FM HD radio, shorten the
telescoping elements slightly.
For all other VHF channels, adjust the angle of the
telescoping elements.
• If your TV has screw terminals for VHF/UHF connection,
connect a 75 to 300-ohm transformer (not supplied)
between the coaxial cable and the VHF/UHF terminals.
• If your TV has a 75-ohm VHF connector and a 300 ohm UHF
connector, connect a signal splitter (not supplied) between
the coaxial cable and the TV’s VHF/UHF connector.
To Next Page
Loading...
Need help?
General
