Radio Shack 4-in-One Smart Light-Up Remote Control User Manual

9
1. Place your original remote control nose-to-
nose with the RadioShack Smart Light-Up
Remote Control.
2. Hold down
P
until the red light blinks twice,
then press
9 7 5
. The red light blinks twice
again.
3. Press the device key (
TV
,
VCR
,
CBL
, or
AUX
) for the mode where you want the
function to reside.
Note:
You can program each smart key for
a different function in each of the four
modes. For example,
1s
might serve as a
MENU key in TV mode and a TRACKING
key in VCR mode.
4. Press one of the smart keys. The red light
blinks rapidly.
5. Hold down the key that you want to copy
on your original remote until the red light
on the 4-in-One Smart Light-Up blinks
twice.
6. Hold down
P
until the red light blinks twice.
7. Press the smart key you programmed. The
key should control the same function as
the key that you copied from your original
remote.
8. Repeat Steps 1–7 to program other smart
keys.
15-1993.fm Page 9 Wednesday, October 20, 1999 12:03 PM

Radio Shack 4-in-One Smart Light-Up Remote Control Specifications

General

Brand	Radio Shack
Model	4-in-One Smart Light-Up Remote Control
Category	Universal Remote
Language	English