©
1999 Tandy Corporation.
All Rights Reserved.
RadioShack is a registered trademark used by Tandy Corporation.
Cat. No.
43-145A
Pocket Tone Dialer
Your RadioShack Pocket Tone Dialer
lets you use computer-based services
(such as alternate long distance or
bank-by-phone) even if your phone
has a rotary dial or uses pulse dialing.
INSTALLING BATTERIES
Your tone dialer uses three AAA alka-
line batteries for power. We recom-
mend RadioShack batteries.
1. Set
ON/OFF
to
OFF
.
2. Push open the battery compart-
ment cover in the direction of the
arrow.
3. Install fresh batteries as indicated
by the polarity symbols (+ and –)
marked in the compartment.
4. Replace the cover.
When the
POWER BATTERY LOW
indi-
cator dims or goes off, or the tones’
volume weakens, replace the batter-
ies.
OPERATION
1. Place the dialer’s rubber ring against
the phone’s mouthpiece.
2. Set
ON/OFF
to
ON
.
3. Dial the desired numbers on the
dialer’s keypad.
To use an alternate long distance ser-
vice (or other computer-based service)
from a rotary or pulse-dialing phone, use
the phone’s dial to call the service’s local
number, then use the tone dialer to com-
municate with the service’s computer.
Operating Tips
The dialer’s tones are strong enough to
activate most equipment, but they might
not work when using the dialer with older
telephones that have weak micro-
phones. In such cases, hold the tele-
phone’s handset vertically, with the
dialer’s rubber ring directly over the
mouthpiece.
To Next Page
Need help?
Power
Weight and Dimensions
