Radio Shack 43-3822 - Operation; Setting the System to Answer Calls

11
3. Release
OGM
when you are
finished. The system automatically
plays back your recorded
message.
7(
7(7(
7(
appears on the
display during the playback.
±
±±
±
12'4#6+10
5'66+0)"6*'"5;56'/"61"
#
059'4"%#..5
1. Press
ON/OFF/STOP
to turn on the
system.
2. When the system answers a call, it
plays the outgoing message,
beeps, then
F7
F7F7
F7
appears on the
display.
±
±±
±
3. The caller can leave a message up
to one minute in length. After the
caller hangs up, is silent for more
than seven seconds, or the
maximum message length is
reached, the system hangs up and
resets to answer the next call. The
number flashes on the display to
indicate an incoming message has
been recorded.
4. When the system answers a call or
records a message, if any phone
±
"016'"
±
"
• To hear the announce
only outgoing
message, press
OGM
.
To stop playback,
press
STOP/ON/OFF
.
• The announce only
message length
reduces total message
recording time. A 20
second message
leaves about 13
minutes, 40 seconds
recording time.
• The system stores up
to 62 incoming
messages.
• If memory reaches
maximum capacity,
while a caller is leaving
a message, it beeps,
stops recording, and
hangs up.
• If memory is full, the
system answers calls,
plays the announce
only outgoing
message, waits for
any remote operation
commands, then
hangs up. You cannot
record messages until
you delete messages.
See “Deleting
Messages” on
Page 15.
Operation
All manuals and user guides at all-guides.com
all-guides.com