6
CH. 1 2 3 4 5
dip switches in different positions and use the
setting which produces the best sound and picture. Make
sure that the camera and monitor are set to the same
channel.
Dip switches
1
to
4
are for channel selection. Switch
5
lets
you set up the auto-sequence timer for four cameras on four
different channels to monitor a series of rooms for maximum
supervision of the house (or office).
±
1. Plug the large AC adapter cord into the
DC 13.5V
jack
on rear left of the monitor.
2. Plug the AC adapter into a standard wall outlet.
3. Rotate the monitor’s
VOL ON/OFF
clockwise to turn on
the monitor and adjust volume to a comfortable
listening level.
4. Adjust the video image using
V-HOLD
(Vertical Hold),
CONT
(Contrast) and
BRIGHT
(Brightness) on the rear
right of the monitor.
5. Locate and orient the antennas on both the camera and
monitor according to “Orienting Antennas for Optimal
Performance” on Page 7.
#WFKQ"1WVRWV
To transfer the monitor’s sound to a TV or to a VCR for
recording purposes, connect the monitor’s
AUDIO OUTPUT
to a TV’s or VCR’s audio input.
8KFGQ"1WVRWV
Connect the monitor’s
VIDEO OUTPUT
to a TV’s or VCR’s
video input for a large screen display, or to record
transmissions.
±
"016'"
±
"
Your Wireless Surveillance System
is factory preset at channel 1 for
one camera use.
To Next Page
Loading...