Radio Shack Satellite/TV/FM In-Line Signal Amplifier

To Next Page

To Previous Page

PROBLEM SOLVING

If the satellite/TV/radio receiver does not operate correctly after you install the In-Line Signal Amplifier:

• Immediately unplug the power injector.

• Check all connections and compare them with the appropriate installation drawing(s) in

this manual.

If no problems are found in the connections:

Plug in the power injector and try the satellite/TV/ra-

dio receiver again. If possible, try a different satellite/TV/radio receiver with the system or try

the satellite/TV/radio receiver with a different antenna system.

If the above procedures do not resolve the problem:

Take the unit to your local RadioShack store

for assistance.

15-1170.fm Page 14 Tuesday, July 13, 1999 4:35 PM

Radio Shack Satellite/TV/FM In-Line Signal Amplifier - Problem Solving