Drive
1.
All
parts of the destination file, including the password, are
the same
as
those of the source file.
COPY
TEST/DAT:0
TO
MYFILE:l
(ENTER)
copies TEST/OAT
on
Drive 0
to
MYFILE/DAT
on
Drive
1.
Since the
destination filespec does not contain
an
extension, it defaults to /DAT
to match the source.
COpy
DATA/NEW:
0
TO
/OLD: 0
(ENTER)
copies DATA/NEW
on
Drive 0 to DATA/OLD
on
Drive
0.
Since the
destination filespec does not contain a filename, it defaults
to
DATA
to match the source.
COPY
TEST/DAT:0
TO
TEST/DAT.CLOSED:l
(CLONE=NO)
(ENTER)
copies TEST/OAT from Drive 0 to Drive 1 and assigns the user and
owner passwords CLOSED. To assign a password to a destination
filespec, the CLONE parameter must
be
turned off.
COPY
DATA/I.J5G:0
TO
DATA/I.J28:1
(LRL=128)
(ENTER)
copies DATA/V
56
on
Drive 0
to
DATAIV28
on
Drive
1.
The LRL of
OATA/V28 is set to 128.
COPY
*KI
TO
*PR
(ECHO)
~TER)
copies from the keyboard to the printer.
As
keys are pressed, they are
sent to the line printer. The keystrokes are visible
on
the video
because the ECHO parameter is specified. Pressing
(CONTROL)(SHIFT)@l)
or
(BREAK)
terminates the copy.
When copying from devspec to devspec, it
is
very important that all
devices specified
be
assigned and active
in
the system. Any routing
or setting affecting the devices may affect the copy.
It
is
very important
to
be aware that you can generate non-ending
loops that lock
up
the system when copying between devices. Be
sure to have a good understanding of this type of copy before you
use
it.
COPY
*KI
TO
KEYIN/NOW:0
(ENTER)
sends the keystrokes entered from the keyboard to the file
KEYIN/NOWon Drive
0.
If
the file already exists, it is written over. To
view the characters
as
you type them, use the ECHO parameter.
Pressing
(CONTROUSHIFT)(@)
terminates the copy.
COPY
TEST/DAT.SECRET:0 (X)
(ENTER)
copies TEST/DATSECRET from one disk to another.
The destination file TEST/OATSECRET
is
visible, and its owner and
user passwords are set
to
SECRET
1-50
To Next Page
Loading...
