Options: Type
System modules resident:
1,
2,
4,
The options line shows you the active system parameters. These
parameters are usually established with the FILTER, LINK, ROUTE,
SET, SPOOL, and SYSTEM library commands.
It
also shows the resident system overlays. (See the SYSTEM
(SYSRES
=)
library command.)
Examples
DEV
I CE
(ENTER)
displays the device table.
DEV
I CE
(D
=
NO)
(ENTER)
displays the TRSDOS options, and turns the drive portion of the
display off. Any new drives or disks are not detected.
DEV
I CE
(B
=
YES)
(ENTER)
enables the device portion of the device table, and displays the entire
table.
DEVICE
(S=NO)
(ENTER)
displays the drive table, and turns the options status portion of the
display off.
DEV
I CE
(P)
(ENTER)
displays the device table, and sends it
to
the printer.
1-67
To Next Page
Loading...
