(2) RS-232C
Connector
Connect
one
end
of
an appro-
priate RS-232C cable
to
th
is
connector.
Connect
the
other
end
of
the
cable
to
the
device with which
you
wish
to
communication.
(3)
PC
Interface
Connector
Plug this
connector
into
the
connector
on
the
left side
of
the
PC-2
or
on
the
rear
panel
of
the
PC-2
Printer/Plotter/Dual
Cassette Inter-
face.
(4) AC
Adapter
To use an external
power
supply
or
to
recharge, plug
the
AC
Adapter
into
the
Interface
Power
Supply
Jack.
(See recharging instructions
before
attempting
to
use
the
PC-2 RS-232C Inter-
face.)
(5) Choke Cable. (U.S.A.
only)
Plug this cable
into
the
Printer/Plotter/Dual
Cassette Interface's External
Power
Supply
Jack.
(6) Metal
Support
Bracket
A.
Protects
the
connection
between
the
PC-2
and
the
PC-2 RS-232C Interface.
(7)
Printer/Plotter/Dual
Cassette Interface Metal
Support
Bracket
B.
Protects
the
connection
between
the
Printer/Plotter/Dual
Cassette Interface
and
the
PC-2
RS-232C Interface. Requires
two
screws
for
attach-
ment
(included
in
the
package).
4
2/
Setting-Up the
PC-2
RS-232C
Interface
The PC-2 RS-232C Interface can be used with
or
without
a
Printer/Plotter/Dual
Cassette Interface.
For
this reason,
there
are
two
sets
of
diagrams which illustrate
how
to
set-up
the
system.
Be
sure
to
turn
all
equipment
OFF
before
attempting
to
connect
the
PC-2 RS-232C Interface.
Connecting the PC-2 to the RS-232C Interface
If
you
are using
the
PC-2
without
a
Printer/Plotter/Dual
Cassette Interface, follow these steps:
1. Slide Metal
Support
Bracket A
into
the
slots located on
the
base
of
the
PC-2 (Figure 2).
Bracket A
Figure 2. Connecting Metal Support Bracket A
to the PC-2.
2. Remove
the
Interface Covers from
both
the
PC-2
and
the
RS-232C Interface. Locate
the
notch
on
the
underside
of
the
PC-2 and slide it
into
the
tab
of
Metal
Support
Bracket A.
5
To Next Page
Loading...