Radio Shack YAMAHA RAPTOR 660R 660R

To Next Page

Yamaha Raptor 660R

60-4352

Installing the Batteries

You will need...

Six AA Batteries for the Raptor (not included)

One 9V Battery for the Transmitter

(not included)

Install Batteries in the Raptor

• Turn the vehicle off.

• Turn the latches on

each side to remove

the battery box.

• Insert six AA batteries

in the battery box,

matching the polarity

symbols (+ and -)

marked inside.

• Replace the battery

box and engage the latches.

Install Batteries in the Transmitter

• Remove the battery

compartment cover.

• Insert one 9V battery

in the battery com-

partment, matching

the polarity symbols

(+ and -) marked

inside.

• Replace the cover.

Driving the Raptor

• Extend the transmitter’s antenna to its

full length.

• Turn the vehicle and transmitter on.

The transmitter’s LED indicator

illuminates.

• Use the transmitter’s control levers to

drive the Raptor.

• Turn the transmitter and vehicle off

when you finish playing with them.

Left Control Lever

• Push forward to move forward.

• Pull backward to move backward.

• Release to stop.

Right Control Lever

• Push left to turn left.

• Push right to turn right.

• Release to make the vehicle go

straight.

Step One

Step Two

Rock from side to side

Stunt Tips

Rockin’ Tilt - When moving

forward or backward, the Raptor

can rock from side to side by

moving the right control lever

rapidly from left to right.

The Big Wheelie - Pop big

wheelies by driving backward and

then quickly moving forward.

Lever

Left Control

Lever

LED

Indicator

Antenna

Right Control

On/O

Switc

On/O

Switc

Pop a Wheelie

Need help?

Do you have a question about the Radio Shack YAMAHA RAPTOR 660R 660R and is the answer not in the manual?