Radio Shack ZipZaps - User Manual

It’s the ultimate radio-control experience! Your Starter Kit comes with a radio controller and a
ZipZaps micro RC with all factory parts. All parts are pre-assembled, race your ZipZaps just
out of the package with a quick charge of about 60 seconds.
. Light up the race track with your ZipZaps headlights.
. Carry your 1:64 scales tunable ZipZaps in your pocket.
. ZipZaps provide great fun for ages 8 and up.
To really rev up the fun factor, customize your ZipZaps micro RC with optional performance
upgrade kits, viewable at the ZipZaps Showroom at www.zipzaps.com and available at your
local RadioShack.
Follow these simple steps to make your ZipZaps race ready.
1. Starter Kit Includes
Your ZipZaps micro RC Starter Kit includes everything you see here.
All parts are pre-assembled and ready to race for your quickest fun.
Controller (illus)
Tires (illus)
Hubcaps (illus)
Body Top (illus)
Chassis (illus)
Motor clip with set screw (illus)
Performance motor with drive gear (illus)
Transfer gear (illus)
Screwdriver (illus)
Rear axle gear (illus)
Wrist strap (illus)
2. Power Up Your Controller
The CONTROLLER charges your micro RC and controls its steering and speed. You’ll need to
install four AAA 1.5V batteries (not included). The ZipZaps factory recommends RadioShack
Enercell Plus alkaline batteries.
1. Set ON/OFF on the CONTROLLER to OFF.
2. Use the SCREWDRIVER stored at the bottom of the CONTROLLER to loosen the
screw and remove the battery compartment cover. (illus)
3. Place four AAA 1.5V batteries in the compartment according to the polarity symbols (+

Radio Shack ZipZaps Specifications

General

Type	Miniature RC Car
Scale	1/64
Frequency	27MHz or 49MHz (depending on model)
Power Source	Rechargeable NiMH battery
Run Time	~5 minutes
Chassis	Plastic
Features	Interchangeable parts

Summary

Starter Kit Overview

Controller Setup and Battery Installation

Powering the Controller

Steps to install four AAA 1.5V batteries into the controller for operation.

Battery Usage Guidelines

Important notes on using fresh, compatible batteries and proper storage to prevent damage.

Charging Your Micro RC

Charging Procedure

How to connect the micro RC to the controller for charging, noting indicator lights.

Charging Cautions

Warnings about removing the RC from the charger and avoiding overcharging to prevent damage.

Driving and Customization

Operating Your Micro RC

Guide to using controller buttons for steering, acceleration, braking, and stopping.

Performance Adjustments

Instructions for adjusting the wheel alignment control for straight driving.

Attaching the Wrist Strap

How to attach the wrist strap to the controller for a secure grip.

Customizing Your Car Parts

Steps for installing upgraded parts like motors, gears, tires, and body tops for customization.

Tips and Information

Zip Tips and Troubleshooting

Troubleshooting common issues, performance tips, and maintenance advice.

Performance Tuning Options

Information on available upgrade kits for performance, body, and power.

FCC and Warranty Information

Details on FCC compliance, interference, and the product warranty.