4
Charge the Drone Battery
Make sure you use the supplied battery and battery charging cable, or one
of the same type: 3.7 V, 530mAH lithium polymer.
1. Use the USB charging cable to connect the battery to a USB power
source. The LED on the USB connector lights red during charging, and
turns o when charging is complete.
A full charge takes about 100 minutes. A fully charged battery provides up
to 7 minutes of ight and camera time.
2. After charging, unplug the USB charging cable. Do not attempt to
overcharge the battery.
3. To install the battery, use a
screwdriver to open the drone
battery compartment door.
4. Match and plug the two ends of the
white battery connectors. They
only t one way, so do not use force.
Neatly slot the battery and cables into
the compartment.
5. Screw the compartment door close.
Note: To recharge the battery, you can
leave the battery inside the drone. Simply unplug the battery connectors, then
follow steps 1-2 to charge using the supplied USB cable.
Lithium Battery Notes
• Do not charge longer than recommended. Unplug the charging cable when
the battery is charged.
• Do not attempt to charge or operate damaged toys.
• Do not puncture or crush. Do not disassemble.
• Do not dispose of lithium batteries in the trash.
• If the electrolyte in the cells should get on your skin, thoroughly wash with soap
and water. If in the eyes, rinse thoroughly with cool water. Immediately seek
medical attention.
2
1
Screw
LED
To Next Page
Loading...
