23 24
the transmission is prohibited.
BUSY: Channel Busy and lock. When the radio receives a matched carrier, transmission is prohibited.
12: CHANNEL NAME
*Note: Only available in Channel Mode
You can edit the name for the current channel.
13:TX INHIBIT
Prohibit the current channel to transmit
15: COMP (Compander)
Compander function will decrease the background noise and enhance audio clarity, especially in long range
communication.
TX Noise Compander:
Compander function will filter the background noise to enhance audio clarity, especially in long range
communication.
Recommend turn on this function when the signal is weak.
16: NC (RX noise compander setting)
RX Noise Compander
Block some background noise while receiving, it is obvious when the signal is weak.
Recommend turn on this function when the signal is weak.
17: 5TONE / 18: 2TONE
Those signaling function similar to CTCSS/DCS signaling. When the receiver adds an optional signaling, the caller
smit matching signaling. DTMF and 5Tone signaling can be applied for other advanced features such as ANI, PTT
ID, group call, select call, remotely stun, remotely kill waken etc..
It is an Optional Signaling, this feature is similar to CTCSS/DCS. When the receiver adds optional signaling, the
caller shall transmit matching signaling. DTMF and 5Tone signaling can be applied for other advanced features such
as ANI, PTT ID, group call, select call, remotely stun, remotely kill waken etc..
*Note: Only available in Channel Mode
19: DSPSUB
The content display at the place of sub-channel
OFF: The sub-channel is empty.
VOLT: Display the current volt
FREQ: Display the current frequency
20: BEEP
Turn on or turn off the Key beep.
21: TOT
The TOT function is used to prevent a too long transmission and limits the tx time: TOT temporarily stops the
transmission if the radio has been used beyond the max pre-set time (for example 15s, 30s, 45s, etc).
22: DTMF
It is an Optional Signaling, this feature is similar to CTCSS/DCS. When the receiver adds optional signaling, the
caller shall transmit matching signaling. DTMF and 5Tone signaling can be applied for other advanced features such
as ANI, PTT ID, group call, select call, remotely stun, remotely kill waken etc..
*Note: Only available in Channel Mode
To Next Page
Loading...
