Need help?Do you have a question about the RadioLink CM210 and is the answer not in the manual?
General| Brand | RadioLink |
|---|---|
| Model | CM210 |
| Category | Battery Charger |
| Language | English |
Ensure safe operation by carefully reading the manual prior to using the CM210 charger.
Connect the CM210 to the power supply before connecting the 2S LiPo battery for charging.
Always keep the charger away from children and pets to ensure safety.
Ensure the charger is supervised at all times while it is charging.
Do not charge batteries exhibiting abnormalities like leakage, bulging, or deformation.
Do not refit or disassemble the charger to prevent damage or hazards.
Keep the charger and battery away from combustible materials during use.
Do not attempt to charge non-rechargeable dry cells with the CM210.
Activates low-voltage cells with a small current to restore battery capacity.
Charges battery cells between 3.0V and 4.16V at 1.5A.
Uses 0.8A for cells above 4.16V to ensure full charge and prevent overcharging.
Adjusts charging current based on internal board temperature for safety.
Adapts charging current if power supply voltage drops to 3.7V.
Ensures consistent battery voltage by balancing cells when voltage differs.
Stops charging and indicates abnormality if no current is detected long-term.
Approximately 40 minutes for a 500mAH 2S battery.
Achieves a full voltage of 4.20V ±0.02V per cell.
Offers a charging efficiency higher than 82%.
Details size, weight, input voltage, battery support, and charging parameters.
Step-by-step guide on connecting the charger and battery for charging.
Explains the meaning of different LED states during operation.
Procedure for performing voltage calibration using multiple power supplies.
To Next Page