RadioPRO RP5-GM31 User Manual

RP5-GM31
Radio Replacement & Steering Wheel Control Interface
with OnStar Retention for General MotorsVehicles
Pacic Accessory Corporation
®
| Santa Ana, California 92705 | Ph. 866-931-8021 | support@pac-audio.com
©2012 Pacic Accessory Corporation
www.pac-audio.com
Rev. 012813
Pacific Accessory Corporation
Introduction & Features
Important Notes
Wiring Connection Chart
Illustration / Schematic
The RP5-GM31 interface allows the replacement of a factory radio in select General Motors vehicles with 29-bit LAN
radios. Using this interface will retain factory features such as OnStar, steering wheel controls (SWC), warning chimes,
Rear Seat Controls (RSC), factory XM Radio and the BOSE amplier when the original radio is removed. The RP5-
GM31 also provides data bus driven outputs such as retained accessory power (RAP), vehicle speed sensor (VSS),
illumination, reverse trigger and parking brake.
1. The radio select rotary switch on the side of the interface must be adjusted to the proper radio setting before plugging the
interface into the vehicle (see next page for setting chart).
2. The interface comes pre-programmed for all of the vehicles factory SWC functions and does not require programming unless
you wish to re-assign the SWC functions to different buttons. The SWC can always be restored to default settings by pressing
and releasing the program button on the side of the interface once and waiting 7 seconds for the LED to ash 3 times.
3. RSC buttons that are identical to the SWC will mimic the SWC one for one.
4. The LED will ash whenever a SWC button is pressed.
Red / White Parking Brake
Output (-)
Purple / White Vehicle Speed
Output
Blue Not Used
Blue / White Amp Turn On Input
Orange / White Illumination Output
(+)
Green Reverse Output (+)
Brown Loop Mute Loop - See
installation note 8.
Aftermarket Radio Connections
Yellow Battery +12v
Black Ground
Red Acc. Output
White Front L + input
White / Black Front L - input
Grey Front R + input
Grey / Black Front R - input
Green Rear L + input
Green / Black Rear L - input
Purple Rear R + input
Purple / Black Rear R - input
SWC Connector
Blu/Yel Kenwwod, Newer
JVC, OEM or
Blaupunkt
3.5mm Jack Alpine, JVC,
Clarion, Pioneer,
Sony, Fusion, Valor,
Boyo, Dual, Visteon
or Advent
SWC Connection
See above chart for
different radio type
connections
x3
Wiring SWC Connection
Page 1
XM R
XM L
Aftermarket
Radio
Connections
Vehicle
Connections

RadioPRO RP5-GM31 Specifications

General

Brand	RadioPRO
Model	RP5-GM31
Category	Car Video System
Language	English

Summary

Introduction and Features

Important Notes

Key points to consider before installation and usage of the interface.

Wiring Connection Chart

Illustration Schematic

Installation Steps

Set Radio Select Switch

Adjust the radio select rotary switch to the proper radio setting before connecting.

Optional Steering Wheel Control Programming

Default SWC Button Assignments

Lists the pre-programmed steering wheel control functions for various radio brands.

Optional Programming Order

Step-by-step guide to reassign SWC functions for different radio types.

Testing and Verification

Using Audio Controls

Using the Radios Dual Zone Source

Controls for rear seat audio when using the factory radio's dual zone source.

Using the Factory XM Radio Tuner

Instructions for controlling the factory XM tuner via the aftermarket radio.

Using the Factory XM Tuner With the SWC

Rear Seat Entertainment (RSE)

OnStar Volume Adjustment

Product Updates (Firmware)