RP5-GM32
Radio Replacement & Steering Wheel Control Interface
with OnStar Retention for General MotorsVehicles
Pacic Accessory Corporation
®
| Santa Ana, California 92705 | Ph. 866-931-8021 | support@pac-audio.com
©2012 Pacic Accessory Corporation
www.pac-audio.com
Rev. 053113
Pacific Accessory Corporation
Introduction & Features
Important Notes
Wiring Connection Chart
Illustration / Schematic
The RP5-GM32 interface allows the replacement of a factory radio in select General Motors vehicles with 29-bit LAN
radios. Using this interface will retain factory features such as OnStar, steering wheel controls (SWC), warning chimes,
Rear Seat Controls (RSC) and the BOSE amplier when the original radio is removed. The RP5-GM32 also provides data
bus driven outputs such as retained accessory power (RAP), vehicle speed sensor (VSS), illumination, reverse trigger
and parking brake.
1. The radio select rotary switch on the side of the interface must be adjusted to the proper radio setting before plugging the
interface into the vehicle (see next page for setting chart).
2. The interface comes pre-programmed for all of the vehicles factory SWC functions and does not require programming unless
you wish to re-assign the SWC functions to different buttons. The SWC can always be restored to default settings by pressing
and releasing the program button on the side of the interface once and waiting 7 seconds for the LED to ash 3 times.
3. RSC buttons that are identical to the SWC will mimic the SWC one for one.
4. The LED will ash whenever a SWC button is pressed.
Aftermarket Radio Connectioons
Yellow Battery +12v
Black Ground
Red Accessory Output
White Front L + input
White / Black Front L - input
Grey Front R + input
Grey / Black Front R - input
Green Rear L + input
Green / Black Rear L - input
Purple Rear R + input
Purple / Black Rear R - input
SWC Connector
Blu/Yel Kenwwod, Newer
JVC, OEM or
Blaupunkt
3.5mm Jack Alpine, JVC,
Clarion, Pioneer,
Sony, Fusion,
Valor, Boyo, Dual,
Lightning Audio,
Visteon or Advent
SWC Connection
See above chart for
different radio type
connections
x3
Wiring SWC Connection
Page 1
Aftermarket
Radio
Connections
Vehicle
Connections
Red / White Parking Brake
Output (-)
Purple / White Vehicle Speed
Output
Blue / White Not Used
Blue Not Used
Orange / White Illumination Output
(+)
Green Reverse Output (+)
Brown Loop Mute Loop - If
aftermarket radio is
equipped with mute wire,
cut this loop and hook
the inside brown wire to
the radios mute wire
To Next Page
Need help?
General
