EasyManua.ls Logo

RadioPRO RP5-GM32 User Manual

RadioPRO RP5-GM32
5 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
RP5-GM32
Radio Replacement & Steering Wheel Control Interface
with OnStar Retention for General Motors Vehicles
Pacic Accessory Corporation
®
| Ph. 866-931-8021 | support@pac-audio.com
©2016 Pacic Accessory Corporation
www.pac-audio.com
Rev. 022516
Pacific Accessory Corporation
Introduction & Features
Important Notes
Wiring Connection Chart
Illustration / Schematic
The RP5-GM32 interface allows the replacement of a factory radio in select General Motors vehicles with 29-bit LAN
radios. Using this interface will retain factory features such as OnStar, steering wheel controls (SWC), warning chimes,
Rear Seat Controls (RSC) and the BOSE amplier when the original radio is removed. Use of this interface also allows
you to program two radio functions to each SWC button by using short press long press dual command functionality.
The RP5-GM32 also provides data bus driven outputs such as retained accessory power (RAP), vehicle speed sensor
(VSS), illumination, reverse trigger and parking brake.
1. The radio select rotary switch on the side of the interface must be adjusted to the proper radio setting before plugging the
interface into the vehicle (see next page for setting chart).
2. The interface comes pre-programmed for all of the vehicles factory SWC functions and does not require programming unless
you wish to re-assign the SWC functions or utilize short press long press dual command functionality. The SWC can always be
restored to default settings by following the procedure outlined on page 3.
3. RSC buttons that are identical to the SWC will mimic the SWC one for one.
4. The LED will ash whenever a SWC button is pressed.
Aftermarket Radio Connections
Yellow Battery +12v
Black Ground
Red Accessory Output
White Front L + input
White / Black Front L - input
Grey Front R + input
Grey / Black Front R - input
Green Rear L + input
Green / Black Rear L - input
Purple Rear R + input
Purple / Black Rear R - input
SWC Connector
Blue/Yellow
Kenwood, Newer
JVC
3.5mm Jack
Alpine, JVC,
Clarion, Pioneer,
Sony, Fusion, Boyo,
Dual, Lightning
Audio, Visteon or
Advent
SWC Connection
See above chart for
different radio type
connections
x3
Wiring SWC Connection
Page 1
Aftermarket
Radio
Connections
Vehicle
Connections
Light Green
Parking Brake
Output (-)
Pink
Vehicle Speed
Output
Blue / White Not Used
Blue Not Used
Orange / White
Illumination Output
(+)
Purple/White Reverse Output (+)
Brown Loop
Mute Loop - See
installation note 7
Pacific Accessory Corporation

Other manuals for RadioPRO RP5-GM32

Question and Answer IconNeed help?

Do you have a question about the RadioPRO RP5-GM32 and is the answer not in the manual?

RadioPRO RP5-GM32 Specifications

General IconGeneral
BrandRadioPRO
ModelRP5-GM32
CategoryRecording Equipment
LanguageEnglish

Summary

Introduction and Features

Important Notes

Key considerations before installation and operation of the interface.

Wiring Connection Chart

Illustration / Schematic

Installation Steps

Default Steering Wheel Control Programming

Default SWC Button Assignments

Pre-programmed functions for steering wheel control buttons for various radio brands.

Optional Steering Wheel Control Programming

Factory Mode vs. Aftermarket Mode

Explains the two modes for SWC programming and their functional differences.

Programming Instructions

Step-by-step guide to program custom SWC assignments for aftermarket radios.

Testing & Verification

Using Rear Seat Audio Controls

Rear Seat Entertainment (RSE)

OnStar Volume Adjustment

Product Updates (Firmware)