Rado Ceramica Multifunction - Different Time Zone (T2); 24-Hour or 12-Hour Display; Stopwatch (CHR)

When the set hours/minutes have
run out, the watch gives an acous-
tic signal.
To switch off the signal: briefly
press the crown.
Note:
The hours and minutes countdown
can be cancelled at any time by
setting to zero: select ‘Timer’ Func-
tion and press the crown for at
least 3 seconds.
5. T2: Different time zone
Select Function 5 (T2).
Pull out the crown: the hours dis-
play flashes. Set the desired time
by turning the crown.
Note:
The minutes and seconds displays
remain unaltered as they are the
same for all time zones.
24-hour display or 212 hours
display
The watch can display 24-hour
clock time or 212 hours (A.M.-
P.M.).
Select Function ‘T2’. To check the
display setting, press the crown
briefly once: if A or P appears, the
time display is 212 hours. If no
letter appears, the 24-hour display
is set. Pressing the crown for a
second time changes the display
setting.
6. CHR: Stopwatch
Select Function 6 (CHR).
Measurement is up to a maximum
of 24 hours, accurate to
1
⁄100th of a
second.
Start - Stop - Re-Start - Stop: press
the crown briefly each time.
Setting to zero: press the crown for
at least 3 seconds.
Note:
With measurement of time seg-
ments longer than one hour, the