Installation Chapter 5
RADWIN 2000 User Manual Release 2.6.40 5-23
The Services and Rates dialog as shown in Figure 5-16 will be different:
Figure 5-19: Services and Rates - RADWIN 2000 C master, RADWIN 2000 clients
The yellow areas should not be used. Using those areas, you may loose the collocated link
with the longest distance between sites.
Asymmetric Allocation and TDM
You cannot use this feature when TDM services are used. Selection of TDM ports as in the
next section will reset the Ethernet balance to 50% in each direction and the green slider will
not appear in subsequent Installation or Configuration runs.
Cancelling TDM port use will make the allocation bar reappear, re-enabling asymmetric Ether-
net traffic allocation.
If you are not using TDM services, clicking Next will take you to Step 8, and completion of
the installation. Your Ethernet capacity allocation will be reflected in Figure 5-35 below.
WinLink 1000
WinLink 1000
RADWIN 2000
Change client to
asymmetric
Asymmetric Allocation slider
not displayed
You cannot do this
Table 5-4: Asymmetric Allocation with Collocated Links - Scenarios (Continued)
HSS Master HSS Client
Scenario: If you try
to...
Result Remarks
To Next Page
Loading...
