Installation Chapter 5
RADWIN 2000 User Manual Release 2.6.40 5-35
The Site B port receive-clock is used as the transmit-clock
for that port on both sides of the link.
Internal/Recover
The Site A port uses its internal oscillator to generate its
transmit clock while the Site B port regenerates the clock
received at the Site A port.
Recover/Internal
The Site B port uses its internal oscillator to generate its
transmit clock while the Site A port regenerates the clock
received at the Site B port.
4. You may configure the E1 ports to unbalanced mode (75 ohm). You should configure
both sides of the link as balanced or unbalanced.
Figure 5-32 shows an adapter cable for connecting devices with balanced E1 inter-
face to the user equipment with unbalanced E1 interface. The Y splitter cable
includes one RJ-45 balanced connector (left) and two unbalances BNC coaxial con-
nectors (right).
Figure 5-32: Unbalanced E1 adapter cable (Y Splitter)
See Appendix B for further technical details.
5. Click Finish to complete the wizard.
To Next Page
Loading...
