RADWIN 2000 User Manual Release 2.6.40 7-1
Chapter 7
Configuring the Link
Overview
This chapter describes the link configuration procedure, which is performed after the installa-
tion of both sides of the RADWIN 2000 link, as set out in Chapter 5.
Link configuration uses a Link Configuration wizard to redefine the configuration parameters
and fine-tune an operational link. Both sides of the link are configured simultaneously.
Link configuration allows you to configure link parameters, which do not lead to sync loss or
require a reset. Some may change service performance, in respect of which, warnings are dis-
played.
For ease of use, the Link Configuration wizard follows the same pattern as Link Installation.
You should therefore be familiar with the content of Chapter 5.
The following parameters are configured using the Link Configuration Wizard:
• System parameters
• Channel settings
• Transmission power and antenna settings
• Service parameters
The Configuration Wizard has seven steps as shown in Table 7-1 below.
To Next Page
Loading...
