Configuration Chapter 7
RADWIN 2000 User Manual Release 2.6.40 7-9
Figure 7-9: Antenna configuration dialog with opened type selection
(Recall that we are using an unrealistically low Tx power here because our link in a labora-
tory.)
So far, the procedure duplicates the corresponding Installation process. If you choose a differ-
ent antenna type and click OK, you will receive the following cautionary message:
You may also change the Required Tx Power, Antenna Gain and Cable Loss. The procedure is
the same as that set out in the Installation procedure on page 5-15.
Switching Between Single and Dual Antennas
Single/Dual Antenna mode selection works precisely the same way as shown on page 5-23.
If you use this option you will receive a warning similar to this:
Caution
In this context, entering Installation mode causes a service break until it is
restored by running the Installation wizard.
If you are uncertain, do not do this without expert technical assistance.
To Next Page
Loading...
