Configuration Chapter 7
RADWIN 2000 User Manual Release 2.6.40 7-12
Figure 7-11: Services and Rates dialog
To choose Services, see the corresponding Installation procedure in Chapter 5.
If you are using a link that -
• is non-collocated
• is Ethernet-only
• uses model RADWIN 2000 C ODUs
then you may use Asymmetric Allocation. You may change the capacity allocation here the
same way as during installation. In place of the IDU box in Figure 7-11, you will see the
Asymmetric Allocation slider:
The procedures for setting the Jitter Buffer and Hot Standby parameters are also the same as
the corresponding procedures in Chapter 5.
Click Next to continue.
Step 7, TDM Clock Configuration
The following dialog is displayed:
To Next Page
Loading...
