Viewing System Details Chapter 8
RADWIN 2000 User Manual Release 2.6.40 8-3
Functions at the top of the dialog box:
To edit the Configuration Parameters:
1. Click the required site button on the main tool bar of the RADWIN Manager
OR
Click Configuration from the main menu and choose a site to configure.
The Configuration dialog box opens (see Figure 8-1 above).
2. Choose the appropriate item in the left hand list to open a dialog box.
3. Click Apply to save changes.
In subsequent instructions, we will simply say “Choose a site to configure” on the under-
standing that the foregoing procedure is implied.
Viewing System Details
This is the first window displayed - as depicted above. You can edit the contact details and
site names.
Viewing Air Interface Details
Click the Air Interface item in the left hand list. A window similar to the following appears:
Advanced
Choose Hub or Bridge ODU mode, IDU aging time, set the
Ethernet ports configuration, set max. information rate, TDM
MHS status, set the external alarm inputs, restore factory
settings, set IDU detection mode.
Backup
Save the current ODU software to a file
Restore
Restore an ODU’s software or configuration from a backup file
created by the backup facility
Refresh
Refresh current panel with latest values
Installation Mode
Return to Installation Mode for the entire link.
Selecting the Mute check box before clicking the Install Mode
button mutes the Beeper.
Buzzer
Mutes the alignment tone in installation mode. Reactivate the
beeper during alignment.
To Next Page
Loading...
