Radwin 2000 Series - Page 17

RADWIN 2000 User Manual Release 2.6.40 xvi
T
ABLE B-4 TRUNK PORTS - E1/T1 RJ45PINOUT .......................................................B-2
T
ABLE B-5 HOT STANDBY RJ-11 PORT PINOUT.........................................................B-2
T
ABLE B-6 IDU ALARM CONNECTOR (DRY-CONTACT).................................................B-3
T
ABLE B-7 TERMINAL BLOCK 3-PIN -48VDC.............................................................B-5
T
ABLE B-8 TERMINAL BLOCK 2-PIN -48VDC.............................................................B-5
T
ABLE B-9 E1 Y SPLITTER PINOUT FOR UNBALANCED MODE.........................................B-6
T
ABLE C-1 SFP TYPE AND INTERFACE DESCRIPTION....................................................C-1
T
ABLE D-1 SUPPORTED RFC 1213 VARIABLES ......................................................... D-5
T
ABLE D-2 PRIVATE MIB PARAMETERS................................................................... D-6
T
ABLE D-3 MIB TRAPS......................................................................................D-31
T
ABLE E-1 IDU-C/E - OUTPUT ALARMS DESCRIPTION ................................................E-1
T
ABLE E-2 IDU-C - INPUT ALARMS DESCRIPTION ......................................................E-2
T
ABLE F-1 SAFETY DISTANCES FOR RADWIN 2000 FCC AND IC PRODUCTS ...................F-1
T
ABLE F-2 SAFETY DISTANCES FOR RADWIN 2000 ETSI PRODUCTS ............................F-1