VLAN Tagging for Ethernet Service: Configuration Chapter 8
RADWIN 2000 User Manual Release 2.6.40 8-31
3. Set untagged port VLAN IDs as required and click OK to accept. At any point you
may return to the last display to see you VLAN assignments.
Completely Disabling VLAN
It may be necessary to disable VLAN for several reasons apart from re-configuration. For
example, setting a VLAN ID to the LAN port used by the managing computer can effectively
lock you out of the link. The remedy for this situation is to reset the relevant site(s) and log
on again. You have “two minutes of grace” before the VLAN settings take hold. During this
Note
The details of setting up VLAN tagging require advanced network
management skills beyond the scope of this manual. Further information for
the Network Manager is provided in Chapter 14.
To Next Page
Loading...
