GSU Preferences Chapter 11
RADWIN 2000 User Manual Release 2.6.40 11-15
GSU Preferences
The Preferences window adds a new tab for the GSU:
Figure 11-14: Site Configuration: Operations
You may chose the units for latitude/longitude coordinates.
GSU Monitoring and Diagnostics
The monitoring and diagnostic reports are similar to those of WinLink 1000.
GSU Telnet Support
To configure the GSU with Telnet, start a Telnet session, using
telnet <GSU_ipaddr>.
For example, if you run Telnet as follows,
telnet 192.168.222.20
you will be asked for a user name and password. You must log on with administrator privilege
under user name,
admin
and password
netman
.
The available commands are the same as for WinLink 1000 with the addition of four addi-
tional display commands and three additional set commands.
The additional display commands are
display rfp
To Next Page
Loading...
