VLAN Tagging for Ethernet Service: Configuration Chapter 14
RADWIN 2000 User Manual Release 2.6.40 14-8
Figure 14-4: VLAN: Ingress modes
The two choices correspond respectively to the two rows of Table 14-1. Choosing Tag
causes the VLAN ID and VLAN Priority fields to become available:
Figure 14-5: VLAN: Ingress mode - setting VLAN ID and Priority
The choices for Egress Mode are -
Figure 14-6: VLAN: Egress modes
The five non-transparent choices correspond respectively to the five rows of Table 14-2 in
the order, row 1, 2, 4, 5, 3.
The first two choices, Transparent and Untag all require no further action.
Untag selected VIDs causes the eight VLAN ID fields to become available:
Note
Throughout this chapter, all VLAN IDs must be between 2 and 4094,
inclusive. All VLAN priorities must be between 0 and 6, inclusive. The values
entered are range-checked. If for example, you enter a VLAN ID of 4095,
then 4094 will be reflected back.
To Next Page
Loading...
