Radwin 2000 Series - Tip: How to Recover a Forgotten ODU IP Address

Tip: How to Recover a Forgotten ODU IP Address Chapter 19
RADWIN 2000 User Manual Release 2.6.40 19-7
Figure 19-7: Main Window after IP Address change
13. Click Cancel to leave the open Management dialog. You may now exit the RADWIN
Manager, or connect to another ODU. If you choose to connect to another ODU,
after about a minute, the main window of the RADWIN Manager will revert to that
shown in Figure 19-2 above. In any event, power down the changed ODU; your
changes will take effect when you power it up again.
Tip: How to Recover a Forgotten ODU IP Address
If you have an ODU with lost or forgotten IP address, use the above procedure to log on to it
using Local Connection. The IP address will appear in the left hand status area:
Note
Some additional things you may want to do now:
•Go to Site Installation | Air Interface. You can enter a Link ID
and change the Installation Frequency and Channel Bandwidth.
• If you log on as Installer, you can change the default band (Chapter
20).
Note
Don’t forget to remove the RF terminators from a connectorized ODU after
powering it down.