Using he RADWIN Manager to set up a 3.X or BRS Link Chapter 21
RADWIN 2000 User Manual Release 2.6.40 21-10
Setting up a link is a two stage procedure:
1. Activate the ODUs by individually by configuring the band, frequency and channel band-
width for the license
2. Complete link configuration in the usual way
To set up a 3.X or BRS ODU:
1. Log on to it as Installer (Operator sufficient for ETSI) and set the IP address as
shown in Chapter 19.
2. Navigate to Site:Location|Air Interface and enter the Link ID for the ODU.
3. Click OK to dismiss the Site Configuration window. Answer Yes to the following popup
message:
4. For ETSI models, skip to step 7 below. For all others, navigate to Tools|Change Band.
The following window is displayed:
5. Choose the required band. For illustration, we will choose the IC band.
6. Click OK to continue and accept the notification message which appears:
To Next Page
Loading...
