Changing the Display Chapter 23
RADWIN 2000 User Manual Release 2.6.40 23-5
From Figure 23-4 above, you can see that the Spectrum View provides clear information
including:
• Spectral measurement for each of the 4 receivers that make a RADWIN 2000 link (two
sites x two antennas per site)
• Spectral power measurements in 5MHz channel granularity
• Current, average and maximum power per channel
• Indication of
• channels free from radars
• channels with radars detected
• barred channels (for DFS bands)
• Indication of scanned and un-scanned channels
• Indication of channels selected for ACS
• Notation of the current operational channel of the RADWIN 2000 link
• Time stamp of the last spectrum scan
• Further, it supports zoom capability, selective view of antennas and sites constituting
the link and selectable detail level
Changing the Display
Moving the mouse anywhere over one the display areas changes it to a cross hair. The mouse
may then be used to select an area for zooming, or to enable a right-click System menu.
Figure 23-5: Mouse pointer active for zooming
Selecting a rectangle and clicking will zoom the channels below it to full panel width:
To Next Page
Loading...
