Setting up QoS Chapter 25
RADWIN 2000 User Manual Release 2.6.40 25-2
Further, you may also limit the maximum information rate (MIR) for each queue per site.
Setting up QoS
You may set up QoS from either the Installation or Configuration wizards. Before doing so, set
up for VLAN (Chapter 14) or Diffserv, depending on which you intend to use.
To define QoS settings for a link:
1. Using either the Installation or Configuration wizards, navigate to the Services win-
dow and chose the QoS tab.
Figure 25-1: Services window with QoS selected
Although QoS is a link-oriented feature, each site may have its own separate param-
eters.
2. Click the Configure button for a site.
Figure 25-2: Ethernet QoS Configuration - Mode selection
3. Choose the required mode - 802.1p (VLAN) or Diffserv.
To Next Page
Loading...
