Disabling QoS Chapter 25
RADWIN 2000 User Manual Release 2.6.40 25-4
• In any event, you may automatically apply the same settings to both link sites:
5. Priorities: You are completely responsible for the completeness and consistency of
your VLAN or Diffserv priorities.
6. Choose a Maximum Information Rate for each queue:
Figure 25-4: MIR choice - per queue
If you previously used Site | Ethernet | Maximum Information Rate (Chapter
8) to globally limit the site, then your choice in Figure 25-4 will also be limited.l
7. Click OK on the exit dialog to accept the settings. If you did not use these settings for
the opposite site, you should configure it now.
8. Complete the wizard in the usual way.
Disabling QoS
In the dialog of Figure 25-2, choose the Disabled mode. The two sites may be enabled or
disabled independently.
To Next Page
Loading...
