Radwin 2000 Series - Getting in to Installation Mode; Using the Configuration Wizard

Getting in to Installation Mode Chapter 26
RADWIN 2000 User Manual Release 2.6.40 26-5
The main window shows a subset of the link operating parameters. The A and B buttons
open Site Configuration for Site A and Site B respectively. The Configure button opens a
Configuration Wizard.
Getting in to Installation Mode
Under certain circumstance you may be better off working in Installation mode, particularly if
you want to change the Operating Band or Operating Channel.To this end, click the managed
site button (A here), Air Interface and then Installation Mode. Figure 26-3 changes:
Figure 26-4: Web interface - Main window, Installation Mode
Using the Configuration Wizard

To configure a link using the Configure Wizard:
1. Start the Wizard by clicking the Configure button. The System page is displayed:
Figure 26-5: Web interface - Configuration System window
The similarity to the corresponding RADWIN Manager Configuration Wizard panel is
quite intentional. The fields have the expected meanings. The Refresh button will
revert your changes to the previous values provide you have not used the Save &
Next button.
2. The second Wizard panel configures the Operating Channel settings:
Note
For the purposes of illustration, we are using a link with 16 E1 ports
configured. The reason for doing this will become apparent below.