Using the Configuration Wizard Chapter 26
RADWIN 2000 User Manual Release 2.6.40 26-8
You will receive the following advisory notice:
3. The next wizard panel displays antenna types and Tx power:
4.
Figure 26-8: Web interface - Antenna settings
The only fields that you can change here are the antenna types. (Required Tx power
may become available for modification in a future release.)
5. Suppose that you change the Site A antenna type to single:
Warning
Changing Operating Channels (for ACS) in either Configuration or
Installation mode is applied immediately upon clicking Save and Next, and
is accompanied by a short sync loss.
To Next Page
Loading...
