Using the Configuration Wizard Chapter 26
RADWIN 2000 User Manual Release 2.6.40 26-10
Figure 26-9: Web interface - Channel Bandwidth settings
7. For this example, leave the Bandwidth as is, and click Save & Next. Here is the
result:
The most obvious indication that something has changed is the reduced number of
available E1 channels (from 16 to 10) reflecting the drop in link capacity due to the
antenna change. Less obvious is the Estimated ethernet Throughput, which has
dropped from 17.5Mbps to 4.9Mbps on both sides of the link.
8. For the purpose of illustration we revert the link to dual antennas at bot sites and run
through the Configure Wizard again. Get to the last panel, Change Bandwidth:
To Next Page
Loading...
