Trap Parameters Appendix D
RADWIN 2000 User Manual Release 2.6.40 D-33
externalAlarmInPort4Alarm 113 major The trap is sent every time an alarm occurs in the External Alarm Input of
port #4. Contains a single parameter which is its description: 1 -
Description: External Alarm 4 - <User Text> - Alarm.
swVersionsMismatchFullCompatibilityAlarm 114 warning The trap is sent if SW versions mismatch with full link functionality.
Contains a single parameter which is its description: 1 - Description:
Software versions mismatch - full link functionality
swVersionsMismatchRestrictedCompatibilityAlarm 115 minor The trap is sent if SW versions mismatch with restricted link functionality.
Contains a single parameter which is its description: 1 - Description:
Software versions mismatch - restricted link functionality
swVersionsMismatchSoftwareUpgradeRequired 116 major The trap is sent if SW versions mismatch and SW upgrade is required.
Contains a single parameter which is its description: 1 - Description:
Software versions mismatch - Software upgrade required
swVersionsIncompatible 117 critical The trap is sent if SW versions are incompatible. Contains a single
parameter which is its description: 1 - Description: SW Versions
incompatible
hssMultipleSourcesDetectedAlarm 118 major Indicates that multiple sync pulse sources were detected. Contains a
single parameter which is its description: 1 - Description: HSS multiple
sync sources were detected.
hssSyncToProperSourceStoppedAlarm 119 major Indicates that synchronization to a proper sync pulse source was
stopped. Contains a single parameter which is its description: 1 -
Description: HSS sync pulse - Down. The reason is: %s. %s - Is the
reason for the sync down.
hssSyncPulseDetectedAlarm 120 major Indicates that HSS additional sync pulse was detected. Contains a
single parameter which is its description: 1 - Description: HSS additional
sync pulse was detected.
tdmBackupAlarm 121 major Indicates that the TDM backup link was activated. Contains a single
parameter which is its description: 1 - Description: TDM backup alarm -
backup link was activated.
linkLockUnauthorizedRemoteODU 122 major Indicates that the remote ODU is unauthorized. Contains a single
parameter which is its description: 1 - Description: Unauthorized remote
ODU connection rejected.
linkLockUnauthorizedODU 123 major Indicates that the ODU is unauthorized. Contains a single parameter
which is its description: 1 - Description: Unauthorized ODU connection
rejected.
hotStandbyAlarm 124 major Indicates that the hot standby secondary link was activated. Contains a
single parameter which is its description: 1 - Description: Secondary
Link Is Active.
sfpInsertion 126 normal Indicates that a device was inserted to SFP Port
sfpPort1DisconnectedAlarm 127 major Indicates the SFP port 1 status changed to disconnected.Contains a
single parameter which is its description: 1 - Description: SFP port 1
status changed to disconnected.
ringRplStateActiveAlarm 128 major RPL state changed to Active.
desiredRatioCanNotBeAppliedAlarm 129 normal Indicates Desired UL/DL RAtio Can Not Be Applied.
cbwMismatch 130 major Indicates that a Channel Bandwidth mismatch was detected.Contains two
parameters: 1 - Description: Channel Bandwidth Mismatch: one side is
%n0 MHz and the other is %n1 MHz. %n0 is the local Channel
Bandwidth value in MHz. %n1 is the remoet Channel Bandwidth value in
MHz.
gpsNotSynchronized 131 major Indicates that the GPS is not synchronized with satellites. Pulses are
self generated.
pdTooHighDueCbwLimitations 132 major Indicates that link cannot be established because link range is too large
for channel bandwidth.
tdmServiceClear 200 major Indicates that TDM Service fault is cleared. Contains a single parameter
which is its description: 1 - Description: TDM Service - Normal.
ethServiceOpened 201 normal Indicates that Ethernet Service has been opened. Contains a single
parameter which is its description: 1 - Description: Ethernet Service has
been opened.
encryptionClear 203 normal Indicates that encryption is OK. Contains a single parameter which is its
description: 1 - Description: Encryption Status - Normal.
Table D-3: MIB Traps (Sheet 3 of 5)
Name ID Severity Description
To Next Page
Loading...
