RADWIN 2000 User Manual Release 2.6.40 5-1
Chapter 5
Installing the Link
Overview
The installation is carried out using the Installation wizard. Its operation is detailed in the fol-
lowing pages in a tutorial style.
For the purpose of explanation, we will set up a laboratory link with the following characteris-
tics:
• Channel selection: Automatic
• Antennas: Dual at both sites
• Services: Ethernet + 7xE1 on ports 1, 2, 3, 8, 10, 11, 14. It is unlikely that you would
use a non-contiguous set of ports - but this shows that if required, it can be done.
The Installation wizard has steps as shown in Table 5-1 below.
To Next Page
Loading...
