Installation Chapter 5
RADWIN 2000 User Manual Release 2.6.40 5-9
Figure 5-8: Channel Settings - Showing available Channel Bandwidths
3. Click the check box if Automatic Channel Selection is required.
4. The Available Channels List contains all of the allowable channels for the link. Check
the channels that can be automatically selected.
Selecting a new channel causes the system quality to change. The Quality bar pro-
vides an indication of the link quality from No serv(ice) (red) to Ethernet + TDM
(green) as shown in the bottom of Figure 5-7 above.
5. Click Next.
Step 4, Tx Power and Antenna Settings
The Tx Power and Antenna Parameters dialog appears.
To Next Page
Loading...
