What to do if Rafiki Protection Twinflex alarms cannot be silenced?
If you're unable to silence the alarms on your Rafiki Protection Security System, it might be because the panel isn't set to ACCESS LEVEL 2. Try entering the access code ('514' for 2/4 zone panels) or operating the key-switch (for 8 zone panels).
Why I am unable to reset my Rafiki Protection Twinflex Security System?
You might be unable to reset your Rafiki Protection Security System for a few reasons. First, make sure all alarms are silenced before attempting to reset the system. Second, the panel may not be set to ACCESS LEVEL 2; enter the access code ('514' for 2/4 zone panel) or operate the key-switch (for 8 zone panel). Finally, check if an alarm condition is still present, and remove the cause of the alarm (e.g., replace broken glass).
What to do if the buzzer is sounding and the POWER FAULT LED is flashing on my Rafiki Protection Security System?
If the buzzer is sounding and the POWER FAULT LED is flashing on your Rafiki Protection Security System, it could indicate a mains supply failure. Wait until the mains supply is restored. If the panel does not revert to normal operation after the power is restored, call an engineer.
How to proceed if the buzzer is sounding and the FAULT LED is lit on my Rafiki Protection Twinflex Security System?
If the buzzer is sounding and the FAULT LED is lit on your Rafiki Protection Security System, it indicates a fault or abnormal condition. Note all illuminated LEDs and call an engineer.
This guide helps the responsible person operate, test, and maintain the fire alarm system.
Defines 'Responsible Person' and 'Competent Person' for fire alarm system duties.
Explains the Twinflex system and the Multipoint detector.
Instructions on actions to take when the fire alarm sounds.
Steps to take if the buzzer sounds without fire alarms activating.
Describes the normal operating mode indicators on the fire alarm panel.
Explains how to access different operational levels on the panel.
Details access procedures for 2 and 4 zone fire alarm panels.
Details access procedures for 8 zone fire alarm panels.
Procedures for the responsible person when an alarm sounds.
Steps to silence alarms after fire procedures are carried out.
How to reset the fire alarm system after an alarm event.
How to activate sounders manually or after they have been silenced.
Overview of responsibilities for fire alarm system testing and maintenance under BS5839.
Details daily, weekly, and quarterly testing procedures for the fire alarm system.
Steps for the user to take after a fire incident.
User actions to assist in identifying false alarms.
User responsibilities when a fault is reported by the control panel.
Log for recording fire and fault events, including actions taken and initials.
General| Manufacturer | Rafiki Protection |
|---|---|
| IP Rating | IP30 |
| Model | Twinflex |
| Zones | 2 |
| Certification | EN54 |
To Next Page