EasyManua.ls Logo

Raider RD-GLM12 - Page 12

Raider RD-GLM12
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
22
23
www.raider.bg
original equipment specications listed in this manual.
• Keep all nuts, bolts and screws tight to be sure the equipment is in safe working condition.
• Never tamper with safety devices. Check their proper operation regularly.
After striking a foreign object, stop the engine, remove the wire from the spark plug, and
thoroughly inspect the mower for any damage.Repair the damage before starting and operating
the mower.
• Never attempt to make a wheel or cutting height adjustment while the engine is running.
• Add fuel before starting the engine. Never remove the cap of the fuel tank or add petrol while
the engine is running or when the engine is hot.
If petrol is spilled, do not attempt to start the engine but move the machine away
from the area of spillage and avoid creating any source of ignition until petrol vapors have
dissipated.
Replace faulty silences. Before using, always visually inspect to see that blades, blade bolts
and cutter assembly are not worn or damaged. Replace worn or damaged blades and bolts in sets
to preserve balance.
Grass catcher components are subject to wear, damage and deterioration, which could expose
moving parts or allow objects to be thrown. For safety protection, frequently check components
and replace with manufacture’s recommended parts, when necessary.
Mower blades are sharp and can cut. Wrap the blade(s) or wear gloves and use extra caution
when servicing them.
Do not change the engine governor setting or over speed the engine. Excessive
engine speeds are dangerous.
Do not adjust the throttle with the engine running.
WARNING: Do not operate the engine in a conned space where dangerous carbon monoxide
fumes can collect.
WARNING: Disengage drive clutches before starting the engine, Stop the engine, wherever
you leave the lawn mower and before refueling, Stop the engine, if lawn mower starts to vibrate
abnormally (check immediately). Reduce the throttle setting during engine shut down and if the
engine is provided with a shut-o󰀨 valve, turn the fuel o󰀨 at the conclusion of moving.
WARNING: Start the engine or switch on the motor carefully according to instruction and with
feet well away from the blade(s).
WARNING: If the fuel tank has to the drained, this should be done outdoors. WARNING: Never
pick up or carry a lawnmower while the engine is running.
WARNING:YOUR RESPONSIBILITY: Restrict the use of this power machine to persons who
read, understand and follow the warnings and instructions in this manual and on the machine.
WARNING:
B.1 Read Operators Manual.
B.2 Keep Bystanders Away.
B.3 Pay more attention to the operators hands and feet to avoid injured.
B.4 The engine exhaust is harmful to your health.
Don’t use inside of house.
B.5 Petrol is highly ammable, avoid exploding,
Don’t incline.
B.6 Be care of heat.
B.7 When repairing, please pick up the spark plug, then repair it according to the operational
manual.
SECTION 3: UNPACKING INSTRUCTIONS
REMOVE UNIT FROM CARTON
(See Figure 3)
Cut tapes at carton and peel along top ap to open carton. Remove loose parts if included with
unit (i.e., owners manual, etc.) Remove packing material.
Take unit out of carton. Check carton thoroughly for loose parts.
DISCONNECT SPARK PLUG WIRE
Before setting up your lawn mower.disconnect the spark plug wire from the spark plug.and
ground it against the engine by attaching rubber boot to a bolt or metal clip to the groundling
post on the engine.See gure-4
SECTION 4: SET-UP INSTRUCTIONS
ITEMS REQUIRED FOR ASSEMBLY
• Pair of pliers ( Not necessary but helpful).
• Motor oil.
• Fresh Gasoline.

Related product manuals