20 www.raider.bg
necessary, remove the empty battery (33).
Insert a charged battery.
Close the battery compartment (32) again.
Switching on the lawn mower
Press and hold the START button (3) for aprox. 3 seconds until the display for (10) lights up.
Switching o the lawn mower
1 . Press and hold the START button (3) for about 3 seconds.
The lawn mower stops if:the STOP button (9) is pressed
the START button (3) is pressed for 3 seconds the cover (1) is raised
it loses the boundary wire signal and does not nd it again within 5 minutes it crosses the boundary
wire when mowing. it gets stuck between obstacles and needs more than 10 seconds to nd a way
out. it is raised
Mowing
Open the cover (1).
When the lawn mower is in the charging station and charging:
Press the START button (3) once. If the battery charge level is more than 70 %, the display shows
“Close the cover to start”. Close the cover(1) and the mower will start mowing automatically.
If the battery charge level is less than 70 %, the display shows “Low battery” after 2 seconds. The
lawn mower charges until the battery charge level is 90 % and then starts mowing automatically.
When the lawn mower is in standby mode:
Press the START button (3) once.
If the battery charge level is more than 30 %, the display shows “Close the cover to start”. Close the
cover(1) and the mower will start mowing automatically.
If the battery charge level is less than 30 %, the display shows “Low battery” after 2 seconds. The
lawn mower moves to the charging sta tion.
Depending on the nature of the grass (height, thickness), the robotic lawn mower adjusts its
mowing speed to ensure a good result.
To Next Page
