RAILBLAZA C-TUG SANDTRAKZ User Manual


CROSSBEAM
KICKSTAND
Slip the bottom of the kickstand into the
inside of one of the crossbeams.

Pull kickstand completely through and ensure the
pins in the kick stand base insert into the indentions
on the inside of the Crossbeam.

Bring the other side of the crossbeam to
meet up against the kickstand side.

Compress both sides of the crossbeam and
you should feel a click as the cross beam pins
t into the opposite side.

HULL PAD
Swivel the hull pad into the hook.

Continue to swivel the hull pad until it is at.
The hull pads will pivot to t your kayak hull.

Slip the wheel over the axle.

CLICK TO
LOCK
Push down on axle pin till it clicks into the lock position. Install straps as shown on back of instructions and
you are ready to use your C-TUG.


RAILBLAZA C-TUG SANDTRAKZ Specifications

General

Brand	RAILBLAZA
Model	C-TUG SANDTRAKZ
Category	Outdoor Cart
Language	English

Summary

C-TUG Cart Assembly Instructions

Attach Kickstand

Slip the kickstand into the crossbeam and ensure pins align with indentions.

Connect Crossbeams

Compress both sides of the crossbeam until the pins click into the opposite side.

Attach Hull Pads

Swivel hull pads into the hook until flat, allowing them to pivot to fit kayak hull.

Mount Wheels

Slip wheels over the axle and push the pin down until it clicks into the lock position.

Caring For Your C-TUG Cart

Cleaning and Maintenance

Hose down with fresh water after use in salt or sandy conditions. Avoid solvents.

Sunlight Exposure

Do not leave the C-TUG in strong sunlight for extended periods to prevent degradation.

Warranty Information

Features a 2-year warranty on SandTrakz wheels and a 5-year warranty on other parts.

Kickstand Placement

Place kickstand opposite the pulling direction to ensure it folds away if it hits an object.