ENGLISH BERTA ADV ELECTROSPONGE
9
Cleaning the tank
BEFORE PERFORMING ANY OPERATION, MAKE SURE THAT THE MACHINE IS UN-
PLUGGED.
Shift the lever (A) to its upright position (figure 2 – page 6).
Raise the water conveyor belt and remove the tank (figure 11).
IMPORTANT
Any material drawn up from the floor deposits in the tank
on the rear side of the machine.
The layer of material that builds up must never be thicker than 2
cm, in order to prevent it blocking the water conveyor belt.
Washing the sponge roller
After cleaning the tank and filling it with cold and clean water, shift the lever (A) to its upright position to raise
the sponge roller off the floor (figure 2 – page 6).
Operate the power switch and with the machine running lower the lever (A) (figure 3 – page 6) and raise it
after 30 seconds.
Repeat this operation several times until the sponge roller is perfectly clean.
When the machine is in rest position, to prevent the sponge roller warping make sure the latter is raised off
the floor and that the lever (A) is in its upright position (figure 2 – page 6).
STORING THE SPONGE ROLLER
Store sponge rollers upright.
Rollers with cellulose sponges must be kept in plastic bags.
Storing the machine
Wash the sponge roller (see “Washing the sponge roller” on page 9).
In the event of long-term storage, remove the sponge roller.
IMPORTANT: QUICK RELEASE DEVICES (F/H – FIGURES 8/9) MUST FIT PERFECTLY INTO
THEIR HOUSINGS.
MAINTENANCE
BEFORE PERFORMING ANY OPERATION, MAKE SURE THAT THE MACHINE IS UN-
PLUGGED.
Grease moving parts on a periodic basis:
chain, bearings, wheel axle, belt tightening rollers.
FIG. 11
IMPORTANT: FOR WASHING USE ONLY WATER. ALCOHOL OR DILUENTS MAY CAUSE THE
SPONGE TO DETACH FROM THE ROLLER.
To Next Page
Loading...