Rainbow E2 User Manual

5 ATTACH STRAIGHT WAND TO THE TOP
CURVED WAND:
Push soft end of the Rainbow hose over raised
ridge on curved handle wand with airflow sleeve
until it “SNAPS” into place.
ASSEMBLE
THE WANDS
6 CONNECT STRAIGHT WAND AND CURVED
HANDLE WAND:
Connect straight wand and curved handle wand
by aligning the button lock on the curved wand
handle with the guide on the wand collar and
sliding together.
7 CONNECT THE TOP STRAIGHT WAND AND
THE BOTTOM STRAIGHT WAND:
Connect the top straight wand and the bottom
straight wand (with floor and wall tool attached)
using the above steps.
8 ADJUST AIRFLOW CONTROL SLEEVE:
Adjust the airflow control sleeve on top of curved
wand. Close opening with airflow control sleeve
for full power. To reduce airflow, rotate airflow
control sleeve so opening in curved wand is
exposed. Adjust as needed for different cleaning
jobs.
5
TROUBLE-
SHOOTING
NOTE:
If the above solutions do
not prove successful,
call your Authorized
Rainbow Distributor.
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
Machine
Won’t Run.
Air inlet screen is plugged
with debris.
Clean off debris thoroughly.
Not firmly plugged in. Plug unit in firmly or try
another outlet.
Rainbow not properly latched
to water basin.
Ensure side latches of water
basin are locked.
Automatic resetting motor
protector has tripped.
Turn Rainbow off. Leave
off for two seconds. Turn
Rainbow back on.
Defective cord, switch
or machine.
Call your Rainbow Distributor
or Rainbow Service Center.
Loss of Airflow.
Machine not correctly
positioned on water basin.
Ensure machine is properly
seated and latched onto
water basin.
Plugged hose, wand
attachment or Power Nozzle.
Remove obstruction from
clogged area.
Incorrect airflow control
sleeve setting.
Adjust airflow control sleeve
setting on curved wand.
HEPA Neutralizer needs
servicing or replacement.
Remove HEPA Neutralizer
and clean or replace.
Machine is running on
low speed.
Turn power switch to
high speed.
Separator is clogged or dirty.
Remove separator and clean.
Discharges Dust. Low level of water in basin. Fill water basin to
correct level.
Excessively dirty water
in basin.
Replace with clean water.
Hole in HEPA Neutralizer.
Call your Rainbow Distributor
or Rainbow Service Center
for replacement.
Heavy Foaming
of Water in
Water Basin.
Soapy contaminant in
water basin.
Replace with clean water.
High level of water in basin. Empty water basin and refill to
correct level.
Musty Odor. Water basin not cleaned or
dumped after use.
Clean water basin and use
Deodorant Air Freshener
while cleaning.
Separator clogged or dirty.
Remove separator and clean.
Damp HEPA Neutralizer.
Refer to page 8.
Machine stored on
water basin.
Do not store machine on
water basin.
Machine
Running Hot, Hot
or Burnt Odor.
Plugged hose, wand,
attachment or Power Nozzle.
Remove obstruction from
clogged area.
Machine not sealed on water
basin properly.
Ensure machine is properly
seated and latched onto
water basin.
Different
Tone, Noise or
Vibration.
Separator clogged or dirty.
Remove separator and clean.
Water level is above center
dome in water basin.
Empty water basin and refill to
correct level.
10

Rainbow E2 Specifications

General

Brand	Rainbow
Model	E2
Category	Vacuum Cleaner
Language	English