6
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS!!!!
SAVE THESE INSTRUCTIONS!!
When installing and using this electrical equipment, basic safety
precautions should always be followed including the following:
1. Danger: To reduce the risk of injury, do not ever permit children to
use the spa without adult supervision.
2. Warning: Risk of Child Drowning: Exercise extreme caution to
prevent unauthorized access by children. To avoid accidents, ensure
that children cannot use the spa unless supervised at all times.
3. Warning: To reduce the risk of electrical shock, replace damaged
or defective wiring immediately.
4. Danger: To reduce the risk of injury to persons, DO NOT
REMOVE Suction Fittings.
5. A pressure wire connector is provided on the side of the control
box to permit connection of a minimum No. 8 AWG (8.4mm) solid
copper bonding conductor between this point and any metal
equipment, metal enclosures of electrical equipment, metal water pipe
or conduit within 5 ft (1.5m) of the unit, as need to comply with local
requirements and/or electrical code. Install the spa at least 5 ft (1.52m)
from all metal surfaces. A spa may be installed within 5 ft of metal
surfaces if metal surfaces are permanently connected by a minimum
No. 6 AWG solid copper bonding conductor attached to the wire
conductor on the terminal box that is provided for this purpose.
(National Electrical Code ANSI/NFPA 70)
6. A Ground-Fault Circuit Interrupter must be installed near the spa
To Next Page
Loading...